Lock body installation

- Mar 07, 2019-

Lock body installation


(1) Make sure that the direction of the lock tongue is consistent with the direction of the door opening. If not, the simple fingerprint lock can be directly adjusted. Use a screwdriver to lift the oblique tongue. Rotate 180° and loosen the screwdriver to reset it.


(2) Then insert the lock body into the opened door hole with the oblique tongue end as the upper end, let the lock body wire pass through the front door hole from the upper door hole, and then fix the lock body with screws.


(3) Put the lock cylinder into the lock body hole from the outside of the door, and fix the lock cylinder with the lock head screw. At this time, the lock body part is installed, and the mechanical key is used to test whether the lock body lock is working normally, and then the panel can be used. installation.